Genco

An employee was moving a loaded lift from an aisle when it became wedged in the aisle and abruptly stopped, throwing the employee. The employee suffered a concussion, and fractures to two neck vertebrae and the left scapula.

An employee was in the basket of an aerial lift while unloading it from a flatbed trailer. The brake released, causing the aerial lift to strike another lift. The employee sustained a partially collapsed lung, rib fractures, and bleeding from the kidneys.

An employee was moving materials using an all-terrain vehicle when the vehicle struck an overhead boom. The employee's head struck against the steering wheel and he was ejected to the concrete ground. The employee was hospitalized with a head injury.

An employee was loading and unloading palletized material with a powered pallet jack. The pallet jack backed up and the employee's leg was crushed between the pallet jack and a bumper/trailer hitch, resulting in fractures to the right ankle and left tibia.

An employee was operating a forklift and went to grab a hold of the swinging arm to swing it into place. His hand was caught between the forklift and the swing arm, resulting in a middle finger amputation.

An employee was operating a rider pallet jack when it struck a stand-up forklift. The forks struck both of the employee's ankles, resulting in hospitalization.

An employee was working to repair a machine with a broken metal stopper. She removed the stopper and used a roll of tape to temporarily secure it. While she was moving it back into place to fix the machine, the residual pressure of the plastic pallets forced the stopper down, resulting in her right thumb becoming stuck between two metal parts. The thumb was amputated.

An employee was changing the battery on his forklift. He removed the forklift's battery plate and exited the battery machine alignment track. The shift lead then went to retrieve a new battery. The employee entered the battery machine alignment track again to unplug the charging cable. The battery changing equipment proceeded forward and pinned the employee against the forklift. The employee was hospitalized with two fractured ribs.

An employee took a picture of the seal and license plate on a delivery truck after loading. The truck then reversed back to the dock and pinned the injured employee against the dock. The employee sustained an abdominal fracture.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.