AMERICAN STEEL AND ALUMINUM, LLC

On January 8, 2025, two employees (one of them a temporary employee) were using a floor crane with a magnet to move steel beams from a platform to a container. A beam fell from the magnet and crushed two fingers on the temporary employee's right hand. He sustained a crushing injury to his right ring finger and an amputation to his right middle finger.

On March 11, 2024, an employee was loading a flatbed trailer on a loading dock when they were struck by a moving load and fell off the side of the trailer, resulting in a fractured right ankle, leg, and foot.

An employee was operating a coil slitter when his finger became caught in the roller, resulting in amputation of his right index finger.

An employee was in the basket of an aerial lift while unloading it from a flatbed trailer. The brake released, causing the aerial lift to strike another lift. The employee sustained a partially collapsed lung, rib fractures, and bleeding from the kidneys.

An employee was moving materials using an all-terrain vehicle when the vehicle struck an overhead boom. The employee's head struck against the steering wheel and he was ejected to the concrete ground. The employee was hospitalized with a head injury.

An employee was loading and unloading palletized material with a powered pallet jack. The pallet jack backed up and the employee's leg was crushed between the pallet jack and a bumper/trailer hitch, resulting in fractures to the right ankle and left tibia.

An employee was operating a forklift and went to grab a hold of the swinging arm to swing it into place. His hand was caught between the forklift and the swing arm, resulting in a middle finger amputation.

An employee was driving a bobtail hostler truck into an underground cave entrance. The truck struck a stationary object inside the cave road system. The employee sustained fractures to a hip and both legs.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.

An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.

An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.

On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.