Daycon Products Company Inc.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

Two employees were working on a forklift with its mast in the air when a chain came loose and the carriage fell down on them. The injured employee was hospitalized with a fractured left ankle, a laceration on the left side of their forehead, and a fractured L1 vertebra.

An employee was operating a machine used to roll erosion control fabric. Her left hand was caught and crushed in the rollers. She was hospitalized.

An employee was using a pipe grooving machine to groove an 8-inch pipe. His gloved index finger on his left hand was caught between the groover and the pipe, crushing the top part of his finger. The employee's left index finger was partially amputated.

An employee was cutting electrical wires when an arc flash occurred, resulting in third-degree burns to their hand.

An employee was being trained on operating a powered industrial truck (PIT) with a side-saddle stance. The employee was instructed to move the PIT s joystick back and forward to get a feel for it. The PIT went backward through a dock door that was approximately 3 feet off the ground. The PIT ended up on the employee. The employee was hospitalized with an amputation below the left knee, third-degree burns to lower extremities, and multiple fractures to the lower extremities.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.

An employee was stocking and ordering the meat case on the sales floor when he slipped and fell due to water on the floor. The employee was hospitalized with a fractured ankle and required surgery.

An employee was working on an exhaust fan on the roof when he tripped on a wire and fell to the ground. The employee sustained scrapes on his elbow, and a fractured right knee with a torn ACL. The employee was hospitalized.

An employee was climbing a scaffold when he slipped and fell 10 to 15 feet to the ground. The employee was hospitalized with a fractured ankle.