Struck by falling part of vehicle or machine, still attached · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Lift Solutions Inc., 1021 S Washington Ave, WICHITA, KANSAS 67211
on — Fractures , affecting the Trunk and other lower extremities.
Final narrative
Two employees were working on a forklift with its mast in the air when a chain came loose and the carriage fell down on them. The injured employee was hospitalized with a fractured left ankle, a laceration on the left side of their forehead, and a fractured L1 vertebra.
Hospitalized Trunk and other lower extremities Vehicle and mobile equipment parts n.e.c.
An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.
An employee had been tasked with hauling large rocks. There was a rock caught in the tailgate of the dump truck that was preventing it from opening. He went to get the rock out and the tailgate came down, crushing his right middle fingertip. The employee sustained a fracture of the distal phalanx and required surgery.
An employee was replacing the wear pan in a wood chipper when a metal sawdust pipe attached to the machine fell from above, pinning him against the machine. The employee suffered a broken right femur, right hip, and left hip.
An employee was hooking up a hydraulic attachment on a forklift. When pressure was released from the hydraulic system's hose, the arm of the forklift came down on the employee's left foot and broke it.
An employee was working to drop the tailgate on a rented dump truck. His right thumb was caught in a pinch point between the tailgate and a retaining chain. He suffered a partial amputation to the thumb, past the last knuckle.
More severe injuries in this industry (NAICS 423850)
An employee was using a pipe grooving machine to groove an 8-inch pipe. His gloved index finger on his left hand was caught between the groover and the pipe, crushing the top part of his finger. The employee's left index finger was partially amputated.
An employee was being trained on operating a powered industrial truck (PIT) with a side-saddle stance. The employee was instructed to move the PIT s joystick back and forward to get a feel for it. The PIT went backward through a dock door that was approximately 3 feet off the ground. The PIT ended up on the employee. The employee was hospitalized with an amputation below the left knee, third-degree burns to lower extremities, and multiple fractures to the lower extremities.
An employee was driving a stand-up forklift through a demising wall pass-through when their left foot became caught between the forklift and a bollard. The employee's foot was crushed and amputated.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.