Edison Power

On November 9, 2023, an employee was removing plywood from the west face of a basement level buck hoist to prepare to dismantle one of the cabs. When the employee pulled on the plywood, it fell and pulled a rope that partially amputated the employee's thumb.

An employee was holding a rigging line and assisting in the removal of an old light pole from its base. When the load was lifted by a forklift, it shifted. The tag line lifted the employee off the ground and propelled him through the air. The employee landed on the ground and sustained back fractures.

An employee was performing maintenance on a bucket truck when his right hand became caught in some rope, causing amputations to three fingers down to the first knuckle.

An employee was conducting a fall rescue demonstration. A 165-pound demonstration dummy was released from a height, putting tension on the lanyard. The employee's left hand, little finger, and thumb were caught in the wire rope lanyard, resulting in a medical amputation of the left little finger as well as lacerations to the left thumb.

An employee was using a crank and cable to lower a light tower due to windy conditions. The light shaft became hung up and released the tension in the cable, which wrapped around the employee's left hand, resulting in amputations of three fingers.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.