Baker Concrete Construction, Inc.

Two employees were using a hose to pour concrete during the construction of a concrete wall. Pressure built up at a 90-degree bend in the hose, causing the water to separate from the rock. The hose began to gyrate violently and spray out concrete. One employee was struck on the arm and the leg by the hose, resulting in a fractured arm and leg. The second employee was struck in the face by a mass of concrete that sprayed from the hose, resulting in a broken nose and facial lacerations. Both employees were hospitalized.

An employee was operating a side-by-side while surveying the jobsite. The vehicle struck a rock and flipped onto its side pinning the employee's left wrist against the ground. The employee's wrist was fractured.

A crane load tipped and knocked over wooden beams, which struck an employee and broke her leg.

An employee was working from a scaffold platform when an I-beam fell and struck their finger, pinching it between the I-beam and the scaffolding frame. The employee's finger was amputated.

An employee was stripping formwork from poured concrete using a prybar when the prybar slipped and caused him to lose balance. The employee stepped back onto a piece of plywood which caused his foot to twist and fractured his right leg.

An employee was fixing a mechanical casket lift in a vehicle when the lift came down on their left-hand fingers, resulting in amputation of two fingers.

An employee was helping to remove the clamp attachment paddles from a forklift so they could then repair a hydraulic leak. The clamp fell and pinned the employee's right ring finger against the mast. The employee's finger was partially amputated.

An employee was on a truck attempting to stow an aluminum extension ladder onto the truck's conveyor boom system. As the conveyor mast was lowered, the boom control area came down on top of the employee's left foot, resulting in two toe fractures.

An employee was standing on the elevated forks of a forklift to install the fork chain anchor nut. The employee slipped and as he went to catch himself, he accidentally engaged the up-down control for the forks. This caused the forks to fall onto his foot. The employee's right foot was crushed and all of his right toes were amputated.

An employee was working on a scissor lift when a portion of the unit came down and struck their head at the lift base. The employee sustained a head laceration and a skull fracture.

An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.

An employee was changing a boom pipe delivery system on a concrete pump truck. He tripped and fell from an elevated level to the ground, resulting in multiple leg fractures.

An employee was reading numbers off a belt that feeds a plant. He reached his hand up and the belt caught his finger, resulting in a finger amputation.

An employee was guiding the pouring end of a concrete pump truck's boom while standing on top of 4-foot wall forms. The boom contacted power lines and the employee was shocked. The employee sustained third-degree burns on the entry and exit path of the electricity, and also sustained first- and second-degree burns to their torso and legs.

An employee was holding a form board on a section of pavement. A skid steer backed into the employee's ankle, breaking it. The employee was hospitalized.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.