105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Takkion OPS Management

Struck by running powered equipment n.e.c. · Amputations, avulsions, enucleations unspecified

Federal OSHA recorded a severe workplace injury at Takkion OPS Management, 24011 CR 54, BURLINGTON, COLORADO 80807 on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Amputation Finger or thumb tip(s), nail(s) Gripping and turning handtools unspecified

Takkion OPS Management

An employee using an overhead crane to move a main shaft of a wind turbine to stage the shaft for transportation. The variable speed crane began to move faster and the load began to swing. The employee went to halt the shaft s swinging and their hand got caught between the main shaft that was swinging and a stationary main shaft. The employee's right arm was fractured, requiring hospitalization and surgery.

Takkion OPS Management

An employee was adjusting a forklift tine when their finger was crushed between the tine and the wooden saddle. The employee sustained a fingertip amputation.

View Takkion OPS Management's full OSHA safety record →

T G Meat Center LLC

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

Burke Builders Inc

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

LMMM Houston #80, LTD.

An employee was using a meat saw to slice pork when the blade amputated their right little fingertip.

Electric Boat Corporation

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

General Thermodynamics, Inc.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Ahtna Marine and Construction Company, LLC

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

Michels Construction, Inc

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

Bechtel Energy Construction Services, Inc.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

Superior Pocahontas LLC

An employee was observing a spool that was pulling tracer wire in order to ensure the wire stayed on track. A strand on the wire disconnected and struck the employee's face, resulting in an avulsion to the scalp and forehead, a concussion, a laceration on the right eyelid, and abrasions around the neck.

ABC Supply Company

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

Burke Builders Inc

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

Circle Graphics, Inc.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

FLATIRON CONSTRUCTION CORP.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

Walmart

An employee tripped over a chair in the break room and fell, resulting in lower back pain. The employee was hospitalized with a fractured vertebra.