Caught in running equipment or machinery during maintenance, cleaning · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Remington Arms Co., Inc., 14 Hoefler Avenue, ILION, NEW YORK 13357
on — Amputations, affecting the fingertip(s).
Watch Remington Arms Co., Inc. — freeGet an email when a new federal OSHA severe-injury report for Remington Arms Co., Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was repairing a barrel threading machine and amputated the left index fingertip when it became caught between the gun barrel and a clamp.
AmputationFingertip(s)Threading and tapping machines
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332994)
An employee was clearing a firearm that had a jam in it. To disassemble the firearm, the employee was required to pull the trigger to remove the slide. During this process, the firearm discharged and the employee suffered a bullet wound to his left hand.
An employee was manually adding soda ash into a tank of heated water while on a mobile ladder. The fluid in the tank began to boil over the sides. The employee went to exit the mobile ladder to avoid the boiling liquid that was beginning to contact their lower legs. The employee lost balance and fell approximately 4 feet to the concrete below. The employee was hospitalized and had surgery for a dislocated left knee and thermal burns to the lower portion of both legs.
An employee was changing the bit on a horizontal gun drill. The wrench slipped while tightening a collet and the employee's left little finger was fractured and partially amputated.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.