Yonkers Contracting Co.

A temporary employee was setting up a roadway construction zone. They were dropping cones from the back of a pickup truck. One of the cones fell and the employee exited the pickup truck to straighten the cone. The pickup truck then backed up and struck the employee causing rib and pelvis fractures.

An employee was walking backward, cleaning a roadway with a flat shovel. A rubber-tracked excavator, also backing up, approached the employee. Its tracks caught the employee's pants, which caused the employee to fall forward. The machine then caught the edge of the employee's foot. The employee suffered bruising to both feet and an ankle, as well as a bone chip on the front of the right heel.

An employee was directing traffic and performing clean-up activities at a site they were preparing for asphalt pavement. The employee was struck by a skid loader that was traveling in reverse, resulting in fractures to the left leg and hip. The employee was hospitalized.

A traffic control employee was assisting a homeowner who was backing out of their driveway when they were struck by an excavator traveling in reverse. The employee sustained a hip and foot fracture.

An employee was flagging for traffic control when he was struck by a truck that was backing up. The employee sustained a punctured lung and broken ribs.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.