Cardi Corporation

On or about April 28, 2015 at 12:30 PM two employees were repositioning a water buffalo on the jobsite. The water buffalo had been delivered by a dump truck so the spring lock handle was positioned and supported too high to be placed onto a pick up truck hitch. To lower the spring lock handle, the employee kicked away the dunnage that was supporting the handle. In the process of removing the supporting dunnage the handle became unstable and fell to the ground, striking the employee's left foot and breaking it.

An employee was cutting a wooden 2-by-4 board. As he cut close to his hand, the saw kicked back and pulled his gloved thumb into the blade, severely cutting his thumb just below the nail.

An employee was directing traffic when a shag truck turned sharply and ran over the employee. They suffered a crush injury to the lower left leg and internal bleeding.

An employee was standing on the street holding a stop/slow paddle and directing the flow of traffic. As they were holding the stop sign, a vehicle attempted to drive around the employee but struck them. The employee sustained fractures to the tibia and fibula and was hospitalized.

A paving crew was working on a roadway when a motor vehicle entered the work zone. Two employees sustained injuries including fractures and damage to internal organs that required hospitalization.

An employee was flagging traffic when they were struck from behind by a car that entered a work zone. The impact of the vehicle threw the employee approximately 45 feet and she landed on another employee. The employee who was struck by the car sustained a head laceration and fractures to the ribs and ankle.

An employee was setting up a worksite on a roadway when they were struck by a vehicle. The employee suffered blunt force trauma to the chest, pelvis, and legs from contact with the vehicle, with subsequent trauma to the neck and head upon falling to the ground.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.