Fall through surface or existing opening, unspecified · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at JTEKT-KOYO, 615 Torrington Drive, DAHLONEGA, GEORGIA 30533
on — Third or fourth degree heat (thermal) burns, affecting the whole body.
Watch Jtekt-Koyo — freeGet an email when a new federal OSHA severe-injury report for Jtekt-Koyo is published. One employer, no account, unsubscribe in one click.
Final narrative
While taking measurements in the heat treatment furnace, an employee stepped onto a non-load bearing support and fell into a vat of 220-degree quench oil. The employee suffered second and third degree burns.
HospitalizedWhole bodyTanks, bins, vats-nonconfined space
An employee was power washing a metal tank from an elevated platform. They fell through a gap between the platform and the tank. The employee landed on the ground and sustained fractures to their ankles and feet.
An employee was installing a metal roof when he stepped on a skylight. The employee fell through the skylight to the ground, resulting in head and shoulder fractures.
An employee was replacing an HVAC unit in a residential home. While he was in the attic space above the garage, the wood he was walking on broke, causing the employee to fall through the sheetrock to the concrete floor below. The employee bumped his head and sustained a shoulder injury as well as a broken ankle.
An employee was putting a tarp on a water tank while standing on a trailer. She lost her footing and fell through the trailer bed, striking the corner of the trailer bed. The employee sustained internal bleeding.
An employee was repairing a sub-floor in a residential house that had water and fire damage. The employee fell through the sub-floor and landed in the basement, resulting in spinal fractures that required hospitalization.
More severe injuries in this industry (NAICS 811310)
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.