Kohler Co.

An employee walked to the truck dock to access the back of his freight truck when his foot caught the edge of a pallet with a battery on it, causing him to trip and fall across the battery on the pallet. The employee suffered five broken ribs.

An employee was moving packed ware from the end of a conveyor to a pallet using a hoist. As the employee raised the hoist, her left index finger became pinched on the lifting device, resulting in a fingertip amputation.

An employee was installing a radiator on a generator. A part fell and struck the employee on the head and left shoulder. The employee suffered head trauma.

An employee was vacuuming above a metal lab. The employee tripped and fell through a guardrail opening, landing 8-10 feet below and suffering possible fractures to the face, wrists, knees, and arms.

An employee was hospitalized with lower back pain after engaging in housekeeping activities.

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was cleaning a machine and bleeding its lines. After the gauge read 0, the employee removed the metal lid covering a filter. The lid popped off and struck the employee in the face, causing a broken nose, a broken jaw, and lacerations.

An employee was burned by an arc flash that occurred in an electrical room.

An employee was carrying a metal plate (18 inches x 18.75 inches) when it dropped onto his right foot, resulting in a fracture.

An employee was troubleshooting a variable frequency drive (VFD). There was an electrical discharge. The employee experienced an electrical shock of approximately 480 volts and sustained second- and third-degree burns on their right hand, wrist, forearm, and elbow.

An employee was operating a press and sustained broken bones in the right hand.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.