Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Georgia Pacific LLC, 1 GP Lane, GURDON, ARKANSAS 71743
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was reaching for a 2x4 board while working with the planer in-feed table. The employee's right thumb went through a 1.5-inch gap in the guarding and was caught between the tipple chain and sprocket, amputating the first digit of the right thumb.
An employee was resetting the chain at the core station. He stepped onto the foot pedal that raises and lowers the hoist as he grabbed the chain and sustained amputation of his left index and ring fingers.
A employee was clearing a wood plug in a dryer when their left glove was caught by the machine. The employee used their right hand to try and free their left and the right hand also became caught in the machine. The employee sustained the amputation of their left arm up to the elbow, and bruising to the right arm.
An employee was prepping cardboard trays for use by nearby equipment when they were struck by a box clamp truck. The clamp attachment struck the employee's left leg, knocking her to the ground. Then the clamp truck ran over her right foot. The employee sustained fractures and lacerations to the foot and toes.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 322121)
Tools and parts were being lowered to the ground from an elevated platform in a 5-gallon bucket. The rope being used to lower the bucket failed; the tools and parts fell and lacerated the left forearm and upper left leg of an employee on the ground.
An employee was tracking an infeed belt on a scrap hogger when their right arm was caught between the belt and a roller. The arm was broken and the employee's shoulder was dislocated. The employee was hospitalized.
An employee was working to clear a jam from a paper napkin folder. The ram that advanced the napkins pushed the employee's right arm into the side of the machine, causing several lacerations and a hairline fracture.
An employee was troubleshooting overflowing ink on a printer-slotter machine when their right ring fingertip was caught in a guarded roller, resulting in a partial amputation.
An employee was disconnecting wires in preparation to swap out a refiner motor when they contacted energized equipment and sustained an electrical shock. The employee was hospitalized.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.