Smith & Wesson Corp.

On November 8, 2016, an employee was hospitalized after tripping over a pallet jack and suffering a leg injury.

An employee was on security patrol and helped a driver enter the establishment. He then observed a trash can with a portion of a pallet sticking out of it. The employee attempted to push it farther down into the can. The piece was too long to move, and the employee had several wood splinters enter his hand. He was hospitalized when his injury became infected.

An employee was working on a CNC machine. The employee stepped back and tripped on the CNC subframe resulting in injury to the lower left leg and hospitalization.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was riding as a passenger in a golf cart on a concrete pathway. The cart hit a bump and the employee fell out, suffering a head injury.

An employee was clearing a firearm that had a jam in it. To disassemble the firearm, the employee was required to pull the trigger to remove the slide. During this process, the firearm discharged and the employee suffered a bullet wound to his left hand.

On July 10, 2024, an employee developed a heat-related illness and was hospitalized with dehydration.

An employee was manually adding soda ash into a tank of heated water while on a mobile ladder. The fluid in the tank began to boil over the sides. The employee went to exit the mobile ladder to avoid the boiling liquid that was beginning to contact their lower legs. The employee lost balance and fell approximately 4 feet to the concrete below. The employee was hospitalized and had surgery for a dislocated left knee and thermal burns to the lower portion of both legs.

An employee was changing the bit on a horizontal gun drill. The wrench slipped while tightening a collet and the employee's left little finger was fractured and partially amputated.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.