Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at National Grid, 2735 Mermaid Ave, BROOKLYN, NEW YORK 11236
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was threading pipe on a threading machine when his glove was caught in the machine, amputating his right pinky finger.
HospitalizedAmputationFinger(s), fingernail(s), n.e.c.Threading and tapping machines
An employee was going to inspect a gas line for damage after the gas line was struck during excavation. The employee was looking into the excavation site when he fell 3 feet into the trench and sustained a left wrist laceration that required surgery and hospitalization.
An employee was descending a step ladder when he contacted a pry bar that was in the ground next to the ladder. The employee sustained a laceration to the leg and buttocks.
An employee was helping to reposition a newly set pole that was being held by a digger derrick. While the winch line and choker chain were under tension, the employee started to rotate the pole. A link of the chain pinched the employee's left ring finger against the pole. The finger was fractured and the fingertip amputated, but was able to be reattached.
An employee was working on a part in the test facility when they made contact with an energized part; 7620 volts of electricity entered their body in the stomach area and exited through their hand, resulting in electrical burns. The employee was hospitalized.
An employee was assisting two co-workers in unloading a pallet jack from a pickup truck bed. The pallet jack began to fall and the employee reached to stop it when his hand went into the pallet jack and his fingertip was amputated by the force of the pallet jack falling down onto his finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 221119)
Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.
An employee was installing personal protective grounds at a substation when their hand contacted the end of the ground that was not energized, but induced voltage was created by wind and shocked them. This resulted in a burn on their thumb.
At about 9:35 a.m. on March 18, 2024, an employee was conducting maintenance on a non-operational fan controller in a switchgear room. The employee pulled the controller and began installing a new one. The employee was electrocuted, suffering third-degree burns to the right hand and fingers as well as burns to the right forearm, and was hospitalized.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.