Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Direct Lumber and Door of Colorado, 1530 E 64th Ave, DENVER, COLORADO 80225
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Watch Direct Lumber and Door of Colorado — freeGet an email when a new federal OSHA severe-injury report for Direct Lumber and Door of Colorado is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was manually feeding 2x4 wood members into a saw when wood cutoffs began interfering with the machine's operation. While attempting to rearrange the wood cutoff debris, his left hand contacted the rotating 10-inch sawblade, amputating one finger and injuring two others.
An employee had been putting trim onto a cart. The employee felt something in his safety boot and took the boot off to check for a foreign body. A trim cart then ran over his foot. He sustained an amputation, without bone loss, of the tip of a toe on the left foot.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was spreading out wood on the live feed table. As he was operating the automatic feed saw, and the wood went in crooked and he went to straighten it. His left middle fingertip was crushed between the wood and the computer monitor. The employee's fingertip was amputated without loss of bone.
An employee was working on a conveyor belt in the chipper room that was not functioning. While inspecting the uncovered gearbox, the conveyor system started. The employee sustained an amputation to their right little finger. The conveyor system was not locked out at the time.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.
An employee was placing trusses on conveyor rollers to be stacked. The rollers could not roll the trusses, so the employee pulled the trusses onto the rollers. One of the spinning rollers caught their hand, resulting in three fingertip amputations.
An employee reached down to pick up a box next to a roller conveyor. His gloved left hand was caught in the chain and pulled into the sprocket. Three fingers were injured: the middle and index fingers were cut to the bone, and the ring finger was amputated at the nail.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.