Metromont

An employee was applying trowel finish to double tees. As the employee started the trowel, he discovered it was set to full throttle. He struggled to get the trowel machine under control. The trowel blade contacted a portion of the double tee side rail. The blade stopped, but the trowel continued to rotate, throwing the employee off of the form and onto the ground on his right side. The employee was then struck by the trowel machine control bar.

An employee was attempting to light a handheld propane torch when an explosion occurred. The employee received second degree burns to the face, hand, and other body parts. A second employee also suffered injuries.

An employee was walking back to her workstation. A forklift reversed a short distance, then completed a U-turn and struck her, running over her lower extremities. She was hospitalized with a broken ankle.

An employee was training on a jockey truck. Upon stepping out of the truck, the employee was struck by a rubber tire gantry crane, resulting in amputations of the right leg above the knee and left leg below the knee.

An employee was standing at the rear of a double pallet jack. Another double jack approached, and the employee's lower leg was caught between the two pieces of equipment. He suffered a broken tibia and fibula.

An employee was unloading large material bags on a loading dock. A forklift tine pinned the employee's foot against a pallet, causing the employee to fall and suffer a broken ankle.

An employee was pushing a container when they were struck by a forklift. The employee sustained a left leg fracture.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was patching precast concrete. He fell from a concrete wall support to the ground due to wind. He was hospitalized with fractures to his left ankle and right knee.

An employee was opening a precast concrete form and rolled his ankle. The employee required surgery on his ankle.

A driver slipped and fell to the ground while exiting his truck. He sustained a lacerated spleen.

An employee was cutting wood on a table saw when the wood got jammed. While clearing the jam, the wood moved forward and his left index and middle fingertips were amputated.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.