Other fall to lower level 11 to 15 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Honeywell Fort Benning, GA, Building 4203 Old Cussetta Road, FORT BENNING, GEORGIA 31905
on — Fractures, affecting the chest, except internal location of diseases or disorders.
Watch Honeywell Fort Benning, GA — freeGet an email when a new federal OSHA severe-injury report for Honeywell Fort Benning, GA is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was inspecting a newly delivered military tank. The wind caught the hatch as it was being opened and caused the employee to fall approximately 11 feet from the top of the tank to the ground below. The employee suffered a broken rib and head lacerations.
HospitalizedChest, except internal location of diseases or disordersTank
The employee was on top of a rail car to level the grain that was deposited into the car when they fell 13-15 feet to the ground. The employee sustained a right leg fracture.
An employee was on an extension ladder installing a satellite dish on a roof when they fell approximately 12-15 feet to the ground. The employee sustained fractures.
An employee was setting a 5-foot pry bar into a precast concrete slab and stood on the end of the pry bar to move the slab into place. The pry bar slipped out causing the employee to fall backward 15.5 feet to the dirt ground. The employee was hospitalized with a broken leg.
An employee was on a step ladder to measure and mark a crane rail for modification. The employee fell approximately 12 to 15 feet to the ground, resulting in a fractured right hip.
An employee was on a trailer securing a load of logs when they fell approximately 9-12 feet to the ground. The employee sustained brain hemorrhaging and lacerations to the thigh and above the eye. The employee was hospitalized.
More severe injuries in this industry (NAICS 811198)
An employee was helping unload steel slit coils on a slitting line, using an overhead crane with a C-hook. The coil did not fit properly onto a turnstile. Another operator went to remove the coil from the C-hook using a forklift while the employee held the C-hook steady. The forklift contacted the coil, causing it to fall from the hook. It landed on the employee s foot, breaking four bones. The incident took place during a training activity.
An employee was trying to open the stuck tailgate of a truck. When he pulled on it, it gave way, causing him to fall back and hit his head on the pavement. He suffered a head laceration/contusion.
An employee was performing a repair and using a radial arm saw when they lacerated their index finger. The employee was hospitalized with an infection.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.