Caught in running equipment or machinery during regular operation · Fractures and other injuries, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Kansas Erosion Products LLC, 3600 Airport Rd, SALINA, KANSAS 67402
on — Fractures and other injuries, n.e.c., affecting the hand(s) and arm(s), unspecified.
Final narrative
While operating an erosion blanket machine, the employee attempted to clean hay out of the machine. His left hand was caught on the belt and his arm was pulled in, causing a broken left ring finger, laceration, and crushing injuries to the left arm.
HospitalizedHand(s) and arm(s), unspecifiedSpecial process machinery, n.e.c.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 541330)
An employee was working to free a load by grabbing and shaking the live side of a tugger line. Once the load became free and progressed upward, the employee's hand was caught and pulled into a snatch block. The employee's right thumb was broken and lacerated. The employee was hospitalized and required a surgical amputation.
An employee was operating a drill rig when when their hand got caught between a 1/4-inch steel cable and a drill rod, resulting in the amputation of four fingers.
An employee was overseeing the operation of a rope being respooled onto the drum of a wire winding machine. He went to remove a piece of wooden reel from the rope. His glove got snagged and his right hand was pulled into the roller, pinching his fingers between the machine's roller and the rope. The middle and index fingers were crushed.
An employee was visiting a patient's home to fit them with a wearable cardiac defibrillator. As he was walking from the front door to his car, a large dog broke free from a chain and attacked him. He was bitten on the forearm and fell. The patient was then able to restrain the dog. The employee was hospitalized with severe dog bites and required surgery.
An employee tripped over a junior I-beam about 4 feet long and 6 inches tall that was installed for circulating water valves and fell to the ground, resulting in a broken right-side rib.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.