Direct exposure to electricity, unspecified · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at Cardone Industries Inc., 5810 East Harrison , HARLINGEN, TEXAS 78550
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Final narrative
An employee was electrically shocked when installing a 3 way switch.
An employee was moving a pallet to turn it in a different direction. A nail gun was about to fall and the employee tried to catch it. As the employee reached for the nail gun, the trigger was activated and the nail gun discharged a nail into the employee's right thigh.
At the differential axle line, an employee sustained the amputation of his right ring fingertip while he was training another employee. A push air gun that the injured employee was holding caused an atlas square fixture to spin which caused the amputation.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 339999)
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.
An employee was climbing an 8-foot ladder to clean windows on a house. The employee was reaching to the right when they lost their balance and slipped. The employee fell and their foot became caught in the ladder rungs, causing both the employee and the ladder to fall to the ground. The employee sustained a fracture to the right leg requiring hospitalization and surgery.
An employee was offloading material using a forklift when the hoisted material began shifting. The employee went to manually stabilize the load and their right middle fingertip was pinched and amputated.
An employee was packing candles on a line. They reached down to pick up a 12-pack of candles when their right little finger was caught in the conveyor belt, resulting in an amputation at the distal joint.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.