CKF, Inc.

An employee was labeling and writing on the back of a slab of quartz. The material was leaned toward him when the A-frame it was resting on shifted, causing the material to fall onto his right leg and break it.

An employee was moving a piece of an I-beam for welding when it rolled off the cribbing. The employee went to catch it when it fell and crushed the employee's finger, resulting in a partial amputation.

An employee was helping to disassemble large reels used to store steel wire when a 264-pound flange from the reel fell over onto the employee's left leg. The employee sustained multiple fractures to their leg and ligament injuries to the lower leg.

The injured employee was putting away materials on the warehouse floor as a co-worker was pushing a pallet onto a nearby shelf. The pallet knocked another pallet forward, causing it to fall onto the injured employee's shoulders. The employee suffered fractures in their right and left knees and ankles.

Employees were moving a single man lift into a building and reclining the lift to position it to fit through the door. The lift shifted and fell, causing the employee to sustain fractures to the left tibia and fibula. The employee was hospitalized and had surgery.

An employee was moving a light tower so it could be hitched to a truck. He grabbed the tongue of the trailer hitch on the light tower to slide it to the left. The tongue jack fell off, causing the light tower tongue to drop on the employee's right hand. The employee's middle fingertip was amputated.

An employee was working to dislodge a piece of stray veneer from a conveyor. The employee set up a ladder against the machine and climbed the ladder. He placed his left hand on the rail of the conveyor and his fingers were caught in the chain and sprocket assembly that powers the conveyor. Three fingers were amputated. The machine was guarded at the time.

A maintenance employee was changing a shaft on a piece of equipment that had been isolated for repair. While positioning the shaft into place, the shaft fell approximately two feet and pinched the employee's left index finger. The employee suffered a partial amputation of the fingertip without bone loss.

An employee was using a cart to move saw blades. The cart tipped over, striking and pinning the employee under the blades. The employee sustained severe lacerations to their torso and legs that required surgery.

An employee was labeling and writing on the back of a slab of quartz. The material was leaned toward him when the A-frame it was resting on shifted, causing the material to fall onto his right leg and break it.

An employee performed maintenance on various machines when they began to feel hot and unwell, and they experienced cramping. The employee was hospitalized with heat stress or dehydration.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.