Diamond Plastics Corp.

An employee was working a piece of pre breaker when the pipe jammed. The employee was cutting the pipe to release the jam when the safety gate struck the tip of the employee's third digit amputating the fingertip.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

An employee was cleaning the floor by a belt conveyor when their right arm contacted the pulley/belting. His arm was pulled into the conveyor assembly, resulting in a fracture to his upper arm.

A backhoe tractor was moving gravel into a 1-foot-deep trench, and an employee was helping spread the gravel. The trench had been partly filled and the tractor was returning to it with a load of stone when its raised bucket struck the employee, who was standing in the trench. He was hospitalized, having suffered an abdominal injury that caused internal bleeding.

An employee was correcting a bend on a brake press when their left middle finger was crushed in the machine.

An employee was inside the frame of a traveling water screen that was up on sawhorses. The employee was working to fit a foot-shaft assembly onto the boot section when their left index finger was crushed and fractured between the sprocket and the set collar or chain. The fingertip was amputated.

On July 26, 2025, an employee was assembling a custom-designed automation line. During troubleshooting, he made contact with a photoelectric sensor that was part of the machine s part detection system. This triggered a small pneumatic crimping cylinder, which activated and came down on the tip of his right thumb, resulting in a partial amputation without bone loss.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.