Westrock the Mahrt Mill

Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.

An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.

An employee was being trained on a machine when a roller came down on their hand, resulting in a fracture and laceration.

An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.

An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.

An employee worked a shift and later experienced cramping in his arms and legs. He was hospitalized with dehydration.

An employee worked in the paper machine area for a shift, cutting corners off paper rolls around the roll machine. Afterwards, the employee sustained cramping and dehydration due to heat. The employee was hospitalized.

An employee was adjusting a trim sheet leading to a sheeter machine. Their glove became caught in the machine and the shearer closed on the employee's right hand, crushing it and breaking the hand and wrist.

An employee was troubleshooting a process upset. A nearby refiner had a pressure spike, causing the housing to separate slightly, which allowed the loss of primary containment. The employee was sprayed by hot water, resulting second- and third-degree burns on his torso and left arm.

On July 22, 2024, at 10:30 AM, an employee was responding to a pulp mill manufacturing process shutdown. Pulp stock overflowed through an engineered overflow pipe resulting in a buildup of stock in a bermed area. The stock was 140 to 150 degrees. The employee went to the bermed area to close an air-actuated process valve. While closing the valve, pulp stock entered the top of his boots and caused second-degree burns to both of his lower legs down to his feet. The employee was hospitalized.

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.