Byers Electrical Construction, LLC

An employee was tailing logs with a chainsaw. As they set the chainsaw on a log, the chain contacted the employee's left index finger, fracturing it. The fingertip was surgically amputated.

An employee was using a Johnson bar to pry a piece of concrete with the help of a skid steer. When the bar moved, the employee was struck in the mouth by it, resulting in a tooth avulsion and a mouth injury that required stitches.

An employee was helping another employee pick up a round piece of metal to recoup a skid. The metal slipped and lacerated the employee's right middle finger, resulting in a fingertip amputation.

An employee was attaching a wrench to a drill rig rod. The wrench turned and struck the employee's right hand, resulting in a laceration and fracture to their index finger.

An employee was climbing a ladder while carrying 12-foot metal trims to the roof. As the top end of the metal rose above the parapet wall of the roof, a strong gust of wind spun the metal backward, causing the employee to lose his grip on the metal. The trims lacerated his left wrist, which required hospitalization and surgery.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.