Other fall to lower level less than 6 feet · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Quad/Graphics Commercial and & Specilty, LLC, 700 Black Hawk Dr., BURLINGTON, WISCONSIN 53105
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was carrying a water form roller down three steps on the back side of a press when he slipped and started to fall. He tried to catch the roller, and his right-hand pinky finger was caught between the roller and stair, amputating the fingertip.
AmputationFingertip(s)Stairs, steps-indoors
More severe injuries at Quad/Graphics Commercial and & Specilty, LLC
An employee was putting a roll into a roll stand. His hand was caught in the roller, and his thumb and middle finger were pinched between the lifting arm and the roll shaft. He suffered avulsions and lacerations to the thumb and the finger,
An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.
An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.
An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.
An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.
An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.
More severe injuries in this industry (NAICS 323110)
An employee opened a 480-volt breaker box and reached inside the breaker box when an uninsulated tool came in contact with one of the legs, causing him to be electrocuted. The employee's arm also got caught on the box, resulting in breaks to both bones in the forearm.
An employee was disconnecting a truck from a trailer. While pulling the fifth-wheel release that the trailer was attached to, the employee lost balance and fell backward onto the concrete pavement, resulting in a fractured T12 vertebra.
An employee was operating a UV coater machine when it began to make a grinding noise. The employee was investigating the vibration of the machine when a gear caught their right index finger and amputated the tip.
A temporary employee was operating a seal machine to seal paper bundles. A jam occurred when the paper and plastic did not properly align to secure the seal. The employee went to clear the jam and the blade on the machine amputated their right middle finger.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.