Carter Sand & Gravel LLC

An employee was using a two-step step stool to stock product on shelves. The stool collapsed and the employee fell to the ground sustaining a fractured femur.

An employee was walking around and closing up the office for the day. As he was on a table closing the blinds, the table collapsed, causing the employee to fall. He sustained a left kneecap fracture.

Employees were demobilizing a microtunneling operation from inside of a 42-foot shaft. They were standing on a 3-foot high pump stand to disconnect the pump when the pump dropped, and the stand gave way. This caused the employees to slide and fall to the ground. The injured employee fell on his left side, landing on an oil can with his co-worker landing on top of him. The injured employee was hospitalized for a rib fracture.

An employee was on a wood platform surrounding a containment wall to work on a transformer. While inspecting the equipment, the wood platform collapsed, causing the employee to fall approximately 4 feet. The employee's shoulder was fractured and required surgery.

An employee was standing on a baker's scaffold approximately 3 feet above finished floor to install equipment. While taking measurements, the locking pins came out on one end of the scaffold, causing the scaffold to collapse. The employee fell 3 feet and sustained a left ankle injury.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.