McNeilus Steel, Inc.

An employee was operating metal shears. The shears' hydraulic stop crushed the last joint on the employee's left little finger, leading to an amputation.

An employee was banding bar stock (three metal pipes) with a pneumatic bander when his right glove and thumb were pulled into a pinch point in the bar stock. His right thumb was partially amputated.

Employees were removing fasteners from an aluminum side sheet of a railcar coal gondola. The side of the rail car collapsed onto the employees' lower extremities, resulting in fractured legs and pelvis and a head injury. Two employees were hospitalized.

An employee was walking by a masonry block wall at the side of a garage. A gust of wind caused part of the wall to collapse onto three employees, one of whom suffered a broken right ankle and a head injury that required staples. That employee was hospitalized.

An employee was tasked with cutting a bale that had a combination of plastic and cardboard. He was using a pair of shears to cut the wire banding when the bale collapsed onto his left leg, breaking his femur. He was hospitalized.

An employee was cleaning her workstation and organizing her files when a section of the acoustical ceiling (tiles and grid), adjacent light fixtures, and portions of the plaster ceiling above suddenly collapsed due to a prolonged, concealed steam leak that weakened the fastener connections. She sustained a cut to her head, bruise to her head, scratches on her neck, a scratch to her left hand, and irritation to her right hand, requiring hospitalization.

An employee was working in a trench box at an excavation site. When he exited the trench box, he sunk into mud up to his knee, suffering possible muscle trauma requiring hospitalization.

An employee fell while entering the building. The employee was hospitalized with a fractured ankle and required surgery.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.

A rolling mill was shut down due to a cobble between two mill stands. The injured employee was cleaning the cobble from the delivery side of stand A, while another employee went to the control panel to move stand B and stand A moved instead. The injured employee's right thumb got caught between the delivery guide of stand A and the looper trough. The tip of his thumb required surgical amputation to the bone to allow for stitches.

An employee was helping another employee load stock material onto a press brake when the stock slipped. The injured employee's right index finger was caught between the press brake die and the stock, resulting in amputation at the first knuckle.

An employee fell from a dock to ground level (less than 4 feet) and broke their tibia/knee.

An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.

An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.

An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.

An employee's left bicep was lacerated by high-pressure water during water blasting operations. The employee was hospitalized.