LMS Construction, Inc.

An employee was power washing a metal tank from an elevated platform. They fell through a gap between the platform and the tank. The employee landed on the ground and sustained fractures to their ankles and feet.

An employee was installing a metal roof when he stepped on a skylight. The employee fell through the skylight to the ground, resulting in head and shoulder fractures.

An employee was replacing an HVAC unit in a residential home. While he was in the attic space above the garage, the wood he was walking on broke, causing the employee to fall through the sheetrock to the concrete floor below. The employee bumped his head and sustained a shoulder injury as well as a broken ankle.

An employee was putting a tarp on a water tank while standing on a trailer. She lost her footing and fell through the trailer bed, striking the corner of the trailer bed. The employee sustained internal bleeding.

An employee was repairing a sub-floor in a residential house that had water and fire damage. The employee fell through the sub-floor and landed in the basement, resulting in spinal fractures that required hospitalization.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.

An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.

An employee was climbing down a ladder when it slipped. The employee fell, suffering a broken scapula and broken ribs. The employee was hospitalized.

An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.

An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.