Fly Tie and Lumber

An employee was trying to clear a slab that was jammed in a saw when his right arm contacted the saw, resulting in an amputation below the elbow. The saw was operational at the time of the incident.

An employee was moving a piece of an I-beam for welding when it rolled off the cribbing. The employee went to catch it when it fell and crushed the employee's finger, resulting in a partial amputation.

An employee was helping to disassemble large reels used to store steel wire when a 264-pound flange from the reel fell over onto the employee's left leg. The employee sustained multiple fractures to their leg and ligament injuries to the lower leg.

The injured employee was putting away materials on the warehouse floor as a co-worker was pushing a pallet onto a nearby shelf. The pallet knocked another pallet forward, causing it to fall onto the injured employee's shoulders. The employee suffered fractures in their right and left knees and ankles.

Employees were moving a single man lift into a building and reclining the lift to position it to fit through the door. The lift shifted and fell, causing the employee to sustain fractures to the left tibia and fibula. The employee was hospitalized and had surgery.

An employee was moving a light tower so it could be hitched to a truck. He grabbed the tongue of the trailer hitch on the light tower to slide it to the left. The tongue jack fell off, causing the light tower tongue to drop on the employee's right hand. The employee's middle fingertip was amputated.

On May 9, 2025, an employee was using an air hose to clear debris from the courtyard area when she slipped and fell. The employee was hospitalized with closed fractures to her left fibula, tibia, and medial malleolus.

On April 24, 2025, an employee was opening a cylinder door on a hydraulic bridge to remove lumber when their left middle finger was caught between the door and the hydraulic bridge, resulting in an amputation without bone loss.

Two employees were using a plywood chop saw. The injured employee was holding one end of the saw with their right hand when the operator on the other end pressed the start button. The saw blade contacted the injured employee's right hand, resulting in multiple finger amputations when it amputated the hand above the thumb.

On January 17, 2025, at 12:15 p.m., an employee was moving 11-gauge steel sheets from a holding cart using a pendant-controlled, 1-ton jib hoist equipped with a plate clamp lifting attachment. With the plate clamp empty and open, the employee began raising the hoist. The clamp became caught on the bottom of the cart, tipping the cart in the direction of the employee. Several sheets of steel slid off the cart and struck the employee, resulting in several broken ribs, a broken left leg and ankle, a fractured kneecap, and a torn left ACL. The employee was hospitalized.

An employee was operating an air hoist to rotate a blending mill counter-clockwise. After he connected the hook to the mill, the hoist was raised and his hand was pinched between the hook block and the ring on the mill. The employee sustained a partial amputation of his right thumb.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.