Struck by running powered equipment n.e.c. · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at Mason's Forest Products, 5571 U.S. 167, RUSTON, LOUISIANA 71270
on — Amputations involving bone loss, affecting the Hand(s) and finger(s).
Final narrative
Two employees were using a plywood chop saw. The injured employee was holding one end of the saw with their right hand when the operator on the other end pressed the start button. The saw blade contacted the injured employee's right hand, resulting in multiple finger amputations when it amputated the hand above the thumb.
HospitalizedAmputation Hand(s) and finger(s) Stationary sawing machinery stationary n.e.c.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
More severe injuries in this industry (NAICS 333243)
On May 9, 2025, an employee was using an air hose to clear debris from the courtyard area when she slipped and fell. The employee was hospitalized with
closed fractures to her left fibula, tibia, and medial malleolus.
On April 24, 2025, an employee was opening a cylinder door on a hydraulic bridge to remove lumber when their left middle finger was caught between the door and the hydraulic bridge, resulting in an amputation without bone loss.
On January 17, 2025, at 12:15 p.m., an employee was moving 11-gauge steel sheets from a holding cart using a pendant-controlled, 1-ton jib hoist equipped with a plate clamp lifting attachment. With the plate clamp empty and open, the employee began raising the hoist. The clamp became caught on the bottom of the cart, tipping the cart in the direction of the employee. Several sheets of steel slid off the cart and struck the employee, resulting in several broken ribs, a broken left leg and ankle, a fractured kneecap, and a torn left ACL. The employee was hospitalized.
An employee was operating an air hoist to rotate a blending mill counter-clockwise. After he connected the hook to the mill, the hoist was raised and his hand was pinched between the hook block and the ring on the mill. The employee sustained a partial amputation of his right thumb.
An employee was driving a reach truck. While making a sharp turn, the employee jumped from the truck and their foot was caught in the wheel, resulting in the amputation of three toes.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.