Repco Inc.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

Two forklift drivers were stopped next to each other and were talking. The injured employee leaned out of their forklift as the other forklift was leaving and they became pinned between the two forklifts. The injured employee was hospitalized with a fractured rib and a lacerated lung.

At about 3:30 p.m. on May 8, 2025, an employee slipped and fell backward while walking around equipment. He landed on the ground, near a water trench into which a steam line and a condensation return line were piped. Hot water from the trench burned his back between the shoulder blades.

An employee was troubleshooting a motor when their right little finger became pinched between the belt and pulley, resulting in amputation of the fingertip.

An employee was driving a forklift to a shipping dock. While he was rounding a corner, a stack of totes fell, and the top of one of the totes struck the outside of his left calf. He was hospitalized.

A crew was preparing a 20-foot section of 12-inch high-density polyethylene (HDPE) pipe to be swung into a welder using an excavator, where it would be welded onto a longer run of pipe. One employee was facing the longer pipe in the welder while the 20-foot section was being rigged. The 20-foot section moved and struck the employee's left knee. The employee's left leg was broken below the knee.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.