Matenaer Corporation

An employee was setting up a new press brake when his finger was caught between the press brake and a part. The tip of the employee's finger was amputated.

An employee was clearing a jam on the slitter machine and amputated a fingertip.

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

A forklift operator was switching out a propane tank on his forklift when the tank leaked and sprayed his right hand, resulting in hospitalization due to liquid propane burns. PPE (gloves) were not worn at the time of the incident.

On September 2, 2025, at approximately 10:15 AM, an employee was setting a rest die in a press when the die slipped off the parallels. One of the employee's fingertips became caught in the die, resulting in a fingertip amputation.

On August 19, 2025, an employee was changing tooling on a sizing machine. The employee's left ring fingertip was pinched between the tooling and the machine and was partially amputated.

An employee was loading pipe into a flare machine when a part clamp caught her right hand. The hand was lacerated and broken. A light curtain was in place at the time of the incident.

A maintenance employee was working on the roof of a small office inside the facility. The employee fell through the ceiling and landed on the floor inside the office. The employee sustained fractured ribs and a punctured lung and was hospitalized.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.