Pedestrian struck by forward-moving vehicle in nonroadway area · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at CHART INDUSTRIES, INC, 1300 AIRPORT DRIVE, BALL GROUND, GEORGIA 30107
on — Fractures, affecting the hip(s).
Final narrative
At approximately 8:04 a.m., on October 17, 2016, an employee was counting stacked sheet metal when she was struck by a pallet being carried by an oncoming forklift. She fell and struck her right side on the concrete working surface, fracturing her hip.
HospitalizedHip(s)Forklift, order picker, platform truck-powered
An employee was dislodging a table in a blast machine that is used to roll material in and out of the machine. The employee's right hand became caught in a belt and pulley system, resulting in a partial amputation to their middle finger.
On December 30, 2023, an employee was pulling a pallet into the back room when a forklift rounded the corner and ran over the employee's right foot. Three of the employee's toes were amputated.
An employee was unwrapping a pallet of empty buckets. The employee stepped backward and was struck by a powered industrial truck carrying a pallet of bucket lids, resulting in a left ankle fracture.
An employee was walking in the racking area to check parts when they were struck by an oncoming forklift. The front wheel ran over the employee's right leg, resulting in fractures to the leg and ankle.
An employee was exiting a trailer for it to be loaded when their right ankle was pinned between a piece of angle iron that was anchored to the floor and a long pallet being pushed by a powered industrial truck (PIT). The employee sustained an ankle fracture and was hospitalized.
A tow truck operator was operating his bed controls on the drivers side when another vehicle crashed into him. The employee sustained fractures to the right femur, hip, and left foot, as well as abrasions to the right knee and a laceration to the right wrist.
More severe injuries in this industry (NAICS 332410)
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
An employee was laying underneath a cooler block while jacking up the tie bar to secure it to horses when the cooler block fell off the horses and onto the employee, resulting in several fractures to the pelvis, clavicle, wrist and tailbone.
An employee was climbing a ladder on a water cooling tower when they fell approximately 15 to 20 feet to the ground, resulting in a fractured left elbow.
An employee was preparing to sand a metal shaft that was loaded into a lathe when his left arm became entangled in the machine. The employee sustained several broken bones.
An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.