Caught, entangled in running powered equipment normal operation · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Chart, Inc., 9660 Grunwald Road, BEASLEY, TEXAS 77417
on — Fractures , affecting the Upper extremities unspecified.
Final narrative
An employee was preparing to sand a metal shaft that was loaded into a lathe when his left arm became entangled in the machine. The employee sustained several broken bones.
An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.
More severe injuries in this industry (NAICS 332410)
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
An employee was laying underneath a cooler block while jacking up the tie bar to secure it to horses when the cooler block fell off the horses and onto the employee, resulting in several fractures to the pelvis, clavicle, wrist and tailbone.
An employee was climbing a ladder on a water cooling tower when they fell approximately 15 to 20 feet to the ground, resulting in a fractured left elbow.
An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.
An employee was rotating a channel ring using a two-hooked wire cable. The channel ring rotated when only one hook was secured. The loose hook grabbed the nameplate of the channel ring and made it fall to the ground. It spun around like a coin and, when it came to a stop, it landed on the employee's foot, resulting in a laceration and tissue damage.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.