Caught in running equipment or machinery during regular operation · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Paxton Contracting, L.L.C., 2702 W. 11th St., KEARNEY, NEBRASKA 68845
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was operating a table saw to cut backing material when the material became snagged and pulled his right hand into the saw blade, lacerating his middle and ring fingers. The saw was unguarded at the time of the incident.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 238310)
An employee was closing a rear trailer door in the parking lot when they were struck by a forklift. The employee's lower left leg was crushed between the pallet on the forklift and the trailer. The employee sustained muscle damage to their lower leg.
An employee was cutting wood with a circular saw. The machine lagged and cut the employee's finger. The employee required surgical amputation of the finger at the hospital.
An employee was climbing a 12-foot ladder when he lost his balance and fell from the eighth rung to the ground. He sustained multiple broken ribs, which caused lung punctures.
An employee was installing spray-on fire proofing from a scissor lift. The scissor lift tipped over and the employee fell, resulting in multiple fractures to their leg, shoulder, and skull.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.