Ball Corporation

An employee was walking down stairs, crossing over the conveyor, and fell. The employee sustained a severe laceration behind the right knee.

An employee was working on a press and went to remove aluminum scrap. The machine single-stroked one time, catching his right thumb between the punch and the bottom former. The thumb tip was amputated.

An employee was working in a robot area. His muscles began cramping in the morning and he was hospitalized that afternoon, suffering from heat stress.

On April 5, 2020, at approximately 2:30 AM, an employee was checking the chain tension on a discharge conveyor. His right index finger became pinched in the conveyor's chain and sprocket and was amputated.

Employees were waiting on a delivery truck to unstrap electrical panels and control panels for unloading. The driver of a tractor trailer unstrapped the electrical and control panels so the employees could unload them. An electrical panel slipped and hit a control panel, which then struck the injured employee, knocking him to the ground where he hit his head on the concrete. He was hospitalized with a contusion to the back of the head and ligament damage to his right knee.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

An employee was clearing a jam on a ring press. The press's secondary switch was activated, engaging it. It caught the employee's hand. The employee was hospitalized and sustained the amputation of two fingers. The machine was unguarded at the time of the incident.

An employee was adjusting an air line on a scroll shear when a rotating gear caught his right ring finger, resulting in a fingertip amputation.

An employee was checking a conveyor belt chain when his right index finger came into contact with the moving chain. He suffered a partial amputation to the right index finger.

On April 1, 2025, at 9:45 p.m. an employee's arm was pulled into a lathe and fractured. The employee was hospitalized.

A paint room operator's hand was caught in the exit conveyor of an automated paint booth, resulting in a left middle finger amputation.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.