Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at MASONITE CORPORATION, 1001 SOUTH 4TH AVENUE, LAUREL, MISSISSIPPI 39440
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was monitoring the production line when he saw that a board on the line was not straight. As he attempted to straighten the board, his left ring finger was caught between the board and a flapper, amputating it just below the fingernail.
An employee was loading fiber board panels onto a conveyor belt when a board jam occurred. When the employee attempted to clear the board jam, the right sleeve of his jacket was caught by the machine, resulting in multiple fractures to his right arm.
An employee was troubleshooting a door machine issue when his right hand entered the point of operation, striking a rotating drill bit and amputating the right ring finger at the base of the hand and the first knuckle.
An employee was using a steel brush to clean glue from the lay-up machine when the steel brush was caught in the rollers. The employee's right hand was then lacerated by the steel brush and rollers, requiring hospitalization.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 321219)
Two employees were investigating smoke originating from a screw at the base of a dry fuel silo. While they were in the ground-level hopper area, a dust explosion occurred. Both employees were burned. One suffered burns to both arms, the face, and the left side of the torso; the other was burned on the face and chest, as well as suffering circumferential burns to the arms.
At 8:00 a.m. on April 22, 2025, an employee was responding to a tracking fault on the bottom head of a six-head sander. While he was straightening the belt, his right hand was pulled in, wedged, and lacerated. He was hospitalized.
On January 20, 2025, an employee was walking between buildings when they slipped on ice and fell. The employee was hospitalized with fractures to their left tibia and fibula.
An employee was swapping motor leads to change the rotation on a river well pump motor when an arc flash occurred. The employee sustained second-degree burns to their hands and forearms.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.