Wenthe-Davidson Engineering Co.

An employee was using a rolling machine to roll flat pieces of metal (about 8" x 12") into a tube that is then seam welded at another machine when the employee's left hand was injured, requiring the surgical amputation of four fingers.

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

A steel tube fell from a straddle truck onto an employee's foot, causing the steel toe of the employee's shoe to press into the employee's left foot. The employee sustained fractured phalanges and was hospitalized.

An employee was unloading materials from the back of a flatbed trailer. The employee fell off the back of the trailer approximately 4 feet to the ground below, resulting in a fractured left collarbone and fractured ribs. The employee was hospitalized.

An employee was bending material in a mechanical brake press when the press rotated and caught his right hand. His finger was crushed between the die and a steel plate, resulting in amputation of the finger.

An employee was cleaning pans containing adhesive by pouring acetone into the pans. After soaking, the employee used a plastic spatula to scrape the paint from the pan. During scraping, a fire spontaneously started underneath the employee near the pan. The employee threw the container of acetone out of the way to avoid it catching on fire, and spilled acetone onto his clothing, causing the fire to spread. The employee suffered burns to both hands and the right calf.

The injured employee was assisting a co-worker to transfer a V-baffle (large piece of angle iron weighing 736 lbs.) into a vessel shell. The injured employee stepped off the end of the vessel and fell backward. The employee sustained a dislocated left shoulder, a fractured left wrist, a fractured lower right leg, and a laceration to the left eyebrow.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.