Adlam Films

An employee was threading film through a machine. The film got caught on the casting drum, pulling the film and employee's arm between a roller and the casting drum. The employee sustained a friction burn.

An employee was cleaning a press roller with ink buildup when his right thumb was caught between two rollers, resulting in a partial amputation of the thumb tip. The pinch point was not locked out at the time of the incident.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was using straps to secure a load inside a transport trailer. The employee was standing on a stack of finished goods that was three pallets high. Each pallet was 16 inches high. He was walking from the stack of three pallets onto a stack of two pallets when he lost his balance and fell onto another stack of finished goods (that was two pallets high) and then landed on the floor of the trailer. The employee was hospitalized with fractured ribs.

An employee was unclogging a resin sifting machine. The rotary sifter's automatic system activated and the sifter blade struck the employee's fingertip, causing an avulsion. The fingertip was medically amputated.

An employee was helping to remove a roll of plastic from a line when the tail stock on the machine snapped back and caught the employee's right middle fingertip, resulting in a partial amputation.

An employee was investigating a possible issue with a piece of equipment when the equipment started and amputated his left index fingertip.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.