Direct exposure to electricity, greater than 220 volts · Second degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at Hard Rock Construction, 3476 Edenborn, METAIRIE, LOUISIANA 70002
on — Second degree electrical burns, affecting the arm(s), unspecified.
Final narrative
An employee was operating an excavator machine approximately four feet from an above ground power line when the power line arced out and electrocuted the employee who suffered second degree burns on the right arm and a broken wrist.
An employee was inside a trench to remove a piece of asphalt from the top of a pipe. A piece of asphalt and part of the trench wall fell and struck the employee, resulting in a dislocated left shoulder and a facial contusion; the employee also experienced tingling in their left hand.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.
An employee was changing a boom pipe delivery system on a concrete pump truck. He tripped and fell from an elevated level to the ground, resulting in multiple leg fractures.
An employee was reading numbers off a belt that feeds a plant. He reached his hand up and the belt caught his finger, resulting in a finger amputation.
An employee was guiding the pouring end of a concrete pump truck's boom while standing on top of 4-foot wall forms. The boom contacted power lines and the employee was shocked. The employee sustained third-degree burns on the entry and exit path of the electricity, and also sustained first- and second-degree burns to their torso and legs.
An employee was holding a form board on a section of pavement. A skid steer backed into the employee's ankle, breaking it. The employee was hospitalized.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.