Joy Global Inc.

The employee was using a miter saw to cut pieces of aluminum that were to be assembled into prototypes for the organization. His thumb was jerked into the saw and was cut.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.

The injured employee was assisting with tightening down 3/4" hardware during assembly of a 6'x20' triple deck screen. Another employee was using a 1/2" cordless impact wrench to tighten down the hardware. The injured employee was using a 1-1/8" open-end wrench that slipped when the bolt was being tighten down by the impact wrench. The injured employee's right ring fingertip was caught between the open-end wrench and the side sheet of the triple deck screen. The tuft of the distal phalanx was amputated.

An employee was welding baffle plates onto a 55-gallon hydraulic tank. A flash occurred as they began to tack weld a part. The employee suffered burns to most of their face and second-degree burns on each arm, resulting in hospitalization.

An employee was cutting a piece of rubber with a utility knife. The knife slipped and partially amputated the employee's right index fingertip.

On July 22, 2024, an employee was using a pressure washer to fill a mop bucket with water. The washer's hose split and soapy water was injected into the employee's right palm and index finger. The puncture wound had to be surgically cleaned.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.