Diamond Restoration of Tampa Bay LLC

An employee was laying out a 2-by-4 for railing on a second floor. The employee fell backward through an opening and landed on a concrete floor about 9.5 feet below, suffering broken vertebrae.

An employee was fixing plaster on a wall when they fell approximately 10 feet through a stair opening.

An employee was a spotter for a trap door that was being tested prior to a show. The trap door activated and the employee fell approximately 8 feet onto stunt mats that were covering the floor below. The employee sustained a fractured right shoulder, a dislocated right ankle, and a sprained left ankle.

An employee was moving a robot when they fell approximately 9 feet through a catwalk hole and landed on the floor. The employee sustained a head injury.

An employee was working in the attic of a modular home. As he was attaching a 2x4, the employee fell 9 feet through the ceiling to the ground. He sustained a fracture near the spinal cord.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.