Kelley Manufacturing Company

An employee was preparing to move steel tubing when a stack of steel rods shifted and pinned his lower leg. He was hospitalized and required surgery.

An employee was using a crane. The hook slipped and a fitting fell onto a finger on the employee's left hand causing a fracture and laceration.

An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.

An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.

An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.

An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.

An employee was working on a portable stainless-steel vessel equipped with a butterfly valve at the bottom. The employee used a crane to raise the vessel and connected an airline to the valve control. Upon activating the compressed air supply, the valve opened. While holding the bottom of the vessel with their left hand, the airline disconnected and the valve closed on their left index fingertip. The employee sustained an avulsion of the fingernail, an open nondisplaced fracture of the distal phalanx, and partial amputation of the fingertip.

An employee was in training to learn how to change steel dies on a culvert machine. The employee was on top of the machine when the handheld control was activated, engaging the machine's auto-run function. The employee's feet were dragged into the roller dies, resulting in a left ankle fracture, a laceration between the ankle and knee, and amputation of the the big toe and second toe on the right foot.

An employee was walking up the stairs in an office area. Their right foot caught the edge of the stair at the top of the stairwell and they fell forward. The employee sustained a neck fracture.

An employee was operating a clipper machine and contacted maintenance when they noticed the machine was not working properly. Maintenance worked on the machine. While verifying that the machine was fixed, the employee's left index finger was amputated above the first knuckle.

An employee was feeding a strip of steel into a power press when it activated and contacted the injured employee's left hand. The employee suffered amputations of the first two digits of the hand.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.