PINE BLUFF, ARKANSAS—
Evergreen Packaging
Struck by swinging or slipping object, other than handheld, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Evergreen Packaging, 5201 Fairfield Rd, , PINE BLUFF, ARKANSAS 71601 on — Fractures, affecting the pelvis.
Final narrative
Employees were moving calendar rolls around in the roll storage area of a deep well. The injured employee was walking between a suspended roll and a roll on the ground when a crane operator changed the direction of travel to avoid striking an adjacent roll. This change of direction caused the suspended roll to pin the employee between the suspended roll and another roll, fracturing his pelvis.
More severe injuries at Evergreen Packaging
PINE BLUFF, ARKANSAS—
Evergreen Packaging
Four employees were pushing a roll of paper on the paper machine winder deck to clear a conveyor for two defective rolls. They lost control of the roll and it struck one employee resulting in a fractured pelvis that required surgery.
PINE BLUFF, ARKANSAS—
EVERGREEN PACKAGING
An employee suffered heat illness (vomiting, cramps, and dizziness) while slabbing cores.
PINE BLUFF, ARKANSAS—
Evergreen Packaging
The employees were bringing the paper machine back online. The waste paper stock went into the overflow chest to be returned to pulp. An employee went out to observe the overflow from the chest in the street to make sure the sewer drain did not clog. As the employee was standing by the sewer drain, the condensate tank released to the same area. The condensate, mixed with the product from the overflow chest, caused the product level at the curb to rise over and into the employee's boots burning his feet, ankles, and lower legs.
PINE BLUFF, ARKANSAS—
EVERGREEN PACKAGING
An employee threading a calendar stack in a paper machine attempted to clear wrap that had wrapped around the stack. The employee's left hand got caught in a nip point, amputating the pinky finger and partially amputating the ring finger.
PINE BLUFF, ARKANSAS—
Evergreen Packaging
An employee had just finished repairing the chip mill saw. While walking on the metal decking, he tripped on saw dust, hit the decking, and fractured his left femur bone.
View Evergreen Packaging's full OSHA safety record →
Similar incidents · Same event type
PORTAGE, WISCONSIN—
InterCon Construction, Inc.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
WYLIE, TEXAS—
RAVA Construction, LLC
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
MIDDLETOWN, OHIO—
Stein, LLC
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
SELMA, TEXAS—
7 Site & Utility, LLC
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
STERLING, ILLINOIS—
Sterling Steel Company, LLC
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 322220)
MERIDEN, CONNECTICUT—
Duro Bag
An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.
LAKEWOOD, NEW JERSEY—
Nekoosa
An employee was shadowing coworkers while in training on the wide extrusion line. The employee went to clean the roller with a rag and cleaner when his right index finger got caught between a powered roller and a rubber roller. The employee sustained an amputation to a finger.
HUNTLEY, ILLINOIS—
Transcontinental H.S. Crocker Inc.
An employee was clearing a jam in a machine when it cycled. His hand was caught in the die, resulting in the amputation of two fingertips.
ROMEOVILLE, ILLINOIS—
Liquibox
While operating a machine, an employee noticed that a piece of plastic material was stuck to a chrome roll. The employee was removing the plastic when their arm came into contact with the rollers. The employee suffered a contusion to the upper arm between the elbow and the shoulder.
ADAIRSVILLE, GEORGIA—
Complete TransPack Solutions, LLC
On June 9, 2025, a machine operator was using a sorting machine to sort/clean plastic sheets. While she was freeing stuck sheets on the lift table, the table engaged and crushed her against the top railing, trapping her torso. The employee was hospitalized with contusions to her back.
More severe injuries in ARKANSAS
BLYTHEVILLE, ARKANSAS—
NATIONAL MILL MAINTENANCE, LLC
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
TEXARKANA, ARKANSAS—
The Goodyear Tire & Rubber Company
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
OSCEOLA, ARKANSAS—
Big River Steel, LLC
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
PINE BLUFF, ARKANSAS—
American Tile & Marble Co., Inc
An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.
SCRANTON, ARKANSAS—
Johnson Industrial Coatings, LLC.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.