Farrar Construction Co. Inc.

A backhoe struck a vent pipe while digging next to it, causing the weld at the bottom of the pipe to fail. The pipe fell and struck an employee on the hardhat. The employee suffered a forehead laceration.

Employee 1 was helping Employee 2 weld a flange to a pipe. Employee 1 was holding a 20" diameter, 2" thick flange in place for Employee 2. The flange was held up by a pipe jack. The flange slipped and Employee 1's fingers were caught between the flange and the pipe jack. His right middle finger was amputated between the first and second joint and his ring finger was amputated at the first joint.

The injured employee was holding a board that was being cut by another employee. The board kicked back, causing the saw to amputate the employee's left little finger and lacerate their left hand, resulting in nerve damage.

On September 26, 2023, an employee was working in a trench box while a co-worker was lowering a piece of plastic pipe by hand using a rope. The pipe swung and struck the employee's hand, fracturing their right thumb and middle and ring fingers. The employee was hospitalized.

An employee went over to a co-worker's station while the co-worker was using a powered meat knife. As the injured employee was pointing, his right index fingertip was amputated.

Two employees were using a handheld banding tool to make banding tape for tent set-ups. One employee was holding the banding tool and the injured employee was looping a metal clip around the tape. The tool closed while the injured employee's hand was near the banding mechanism. The banding tape caught the employee's right ring finger as it tightened, resulting in a partial amputation.

An employee was holding a branch against a log on the ground to make a wedge while another employee was using a chainsaw to cut the wedge. The saw slipped and struck the employee holding the branch, resulting in a laceration to the right wrist.

An employee was acting as a spotter for a forklift operator. While its forks were being raised, the forklift came into contact with a power line. The employee was touching the forklift's metal frame at the time and was shocked on the left palm. The employee suffered burns to both the left palm and the sole of the left foot.

An employee was leaning down to install conduit. When he stood up, a 2-inch all-thread rod caught and lacerated his left eyelid.

An employee was working as a fire watch. The employee was exposed to anhydrous ammonia and was not able to see while climbing down a ladder due to eye irritation. The employee fell and was hospitalized for a broken ankle.

An employee was standing on the ground awaiting the lowering of a pipe. After the pipe was lowered to the ground by a skid steer, it rolled and struck the employee's left leg. The employee was hospitalized with a fractured leg.

An employee was tightening a gas pipe with a wrench when the wrench slipped from his hand. The employee's arm then hit a metal cross-brace, resulting in a lacerated arm.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.