Universal Stainless & Alloy Products, Inc.

An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.

An employee was approaching a plant entrance with a lit cigarette. When he discarded the cigarette, it ignited oxygen that had been released during a tank-filling process. The employee suffered third-degree burns over 60 percent of his body.

An employee was using an overhead crane to lower material onto a table. His left-hand fingers got caught between the material and the table. Four fingers were broken.

An employee was positioning molds onto a car using a remote control crane when the two molds that were on the crane moved and pinned his leg between the two molds on the crane and the two stationary molds. His right femur broke.

An employee was checking the function of newly installed actuators when they were struck by a pressurized release pipe. The employee suffered fractures to the orbital socket and shoulder, requiring hospitalization.

A ramp in the trunk of a delivery van struck an employee's calf. She suffered a broken leg and was hospitalized.

An employee was completing a service call and looking at a water pump when the pump cover plate struck their forehead. The employee sustained a forehead laceration and fracture requiring hospitalization.

An employee was removing chains from a steel tube. A sorting hook attachment was caught on the staging area cross member. When he raised the chains, the sorting hook snapped back and struck the employee's face causing a fractured jaw.

An employee was in the sawmill basement using a push broom and shovel to clean wood chips and sawdust. The employee's right arm was struck by a wooden board between the wrist and elbow, resulting in a fracture.

An employee fell while entering the building. The employee was hospitalized with a fractured ankle and required surgery.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.

A rolling mill was shut down due to a cobble between two mill stands. The injured employee was cleaning the cobble from the delivery side of stand A, while another employee went to the control panel to move stand B and stand A moved instead. The injured employee's right thumb got caught between the delivery guide of stand A and the looper trough. The tip of his thumb required surgical amputation to the bone to allow for stitches.

An employee was helping another employee load stock material onto a press brake when the stock slipped. The injured employee's right index finger was caught between the press brake die and the stock, resulting in amputation at the first knuckle.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.