Caught in running equipment or machinery, n.e.c. · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at Conestoga Wood Specialties Corporation, 245 Reading Rd, EAST EARL, PENNSYLVANIA 17519
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was servicing a moulder and checking the alignment of the cutter when the machine activated cutting his right middle, ring and pinky fingers. The employee was hospitalized and had surgery on his hand.
An employee was clearing a small piece of wood that had jammed in the back of a machine. A cutting blade in the machine lacerated the employee's right forearm. The employee was hospitalized, requiring surgery.
A forklift had just placed a pallet on the third or fourth level of some racking. The pallet fell through the racking and struck an employee's head, then trapped his lower body under it. He suffered a head laceration and lower extremity injuries.
A doorframe assembly press activated while an employee was adjusting the clamps on the machine, and their right index finger was caught between the press's clamp and a doorframe. The fingertip was amputated.
An employee was repositioning a wooden board that did not feed properly into a saw. The board then became jammed. The employee reached to grasp the board and their left middle finger became stuck between the fence and a moving chain, resulting in a fingertip amputation.
Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.
An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.
More severe injuries in this industry (NAICS 337110)
An employee fell to an office floor, landing on her right side and suffering a broken hip, a broken right arm, and a concussion. She was hospitalized, requiring surgery.
An employee was clearing a small piece of wood that had jammed in the back of a machine. A cutting blade in the machine lacerated the employee's right forearm. The employee was hospitalized, requiring surgery.
An employee was operating a stand-up forklift to travel from the warehouse to the breakroom area. The forklift struck the breakroom wall, causing a fracture/crush injury to his left foot.
An employee was cutting a piece of wood with a table saw. The wood bound in the saw, which then pulled the employee's right hand into the blade. His middle finger was cut and fractured.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.