Struck by swinging or slipping object, other than handheld, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at EXMARK MANUFACTURING COMPANY, 2101 ASHLAND AVE, BEATRICE, NEBRASKA 68310
on — Fractures, affecting the forearm(s).
Final narrative
The injured employee was hanging parts on the paint conveyor. A forklift operated by another employee in the area was dropping off a pallet of parts. As the forklift backed up, it snagged the hanging pendant control for the overhead hoist. The pendant control was flung back towards the employee hanging the parts and struck the employee's left arm resulting in a fractured forearm.
An employee was handling mower deck sheets when his right middle finger was caught between two steel lawn mower decks on the pallet. His fingertip was amputated.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 333112)
At 12:55 p.m. on October 8, 2025, a pneumatic cylinder press was activated while an employee's hand was resting on it. The moving shaft and top portion of the machine descended, catching the employee's right middle finger and amputating the fingertip (without bone loss).
An employee had been providing lawncare service and was driving back to the main facility when he experienced severe cramping due to heat stress. The employee was hospitalized for dehydration.
At about 5:15 p.m. on June 14, 2025, an employee was using a walk-behind mower to mow middle islands along a road. A support truck with an arrow board sign was following behind to control traffic. The truck lurched forward and struck the employee from behind, pinning the employee against the mower. The employee suffered a fractured hip, a right iliac wing fracture, right femoral nerve damage, and puncture wounds to the right leg. The employee was hospitalized.
A welder in the fabrication shop was straightening a wheel tab with a hammer and struck his left hand. The employee was hospitalized with a fractured hand.
A sprayer boom assembly fell off a sawhorse when the C-clamp was removed and it struck an employee. The employee suffered a separated collarbone and three broken ribs.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.