Fall on same level due to tripping, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Waste Connections of Colorado, 1830 Weld County Rd 5, ERIE, COLORADO 80516
on — Fractures, affecting the leg(s), unspecified.
Final narrative
An employee was trying to evade bees when he tripped and fell, breaking his right leg.
An employee backed a garbage truck into an alley, stopped the truck, and got out. While the truck was dumping, he realized it was slowly going backward, and he tried to get to the door. His left hand was trapped and scraped between the door and the brick wall of a building, and the little finger was amputated. The incident occurred during a training activity.
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 562212)
A driver had backed up a rear load truck to a dumpster. The winch cable was bound, and another employee went to use the controls to put slack in the line. The cable tightened instead of loosening while the driver was holding it, and it caught his hand against the truck and crushed his thumb. The thumb was fractured and lacerated; he was hospitalized, requiring surgery. The incident took place during a training activity.
An employee was pulling into a customer's parking lot to pick up a roll-off container when the vehicle ran over the median curb. The vehicle then veered to the left, striking the side curb and the retaining wall. The employee sustained injuries to his neck and spine, as well as a damaged artery, a head laceration, and fractured ribs.
An employee was replacing the bracing arm of a baler. The replacement part (weighing an estimated 500 pounds) was moved into place using a truck-mounted crane with a lifting strap attached to the designated pick point. The employee then used his right hand to stabilize/align the part. The part shifted, crushing his right index finger against the mounting pin hole. The employee's finger was amputated above the first knuckle.
An employee was moving a mower with a tractor bucket when the bucket slipped and struck another employee on the hand. The injured employee sustained a partial amputation of their left little finger.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.