Penske Truck Leasing Corporation

Two employees were working on a boom truck that had outriggers and a leaking hydraulic cylinder. The injured employee had removed the hydraulic cylinder, rebuilt it, and reinstalled it. While verifying that the repair was correct, a bolt fell into the frame rail. As the injured employee reached to retrieve the bolt, the hydraulic cylinder went into motion resulting in amputation of the first knuckle from the right index finger.

An employee was working on a truck at a fuel station when the truck back-fired and ignited the gasoline vapors, causing second degree burns to both of the employee's arms.

An employee was using a cutting torch to cut a clutch from the bottom of a truck when hot grease inside the clutch box melted and dripped onto the employee's face, burning it.

While running to stop a truck that was moving without a driver, an employee fell and broke his hip.

An employee was moving a piece of an I-beam for welding when it rolled off the cribbing. The employee went to catch it when it fell and crushed the employee's finger, resulting in a partial amputation.

An employee was helping to disassemble large reels used to store steel wire when a 264-pound flange from the reel fell over onto the employee's left leg. The employee sustained multiple fractures to their leg and ligament injuries to the lower leg.

The injured employee was putting away materials on the warehouse floor as a co-worker was pushing a pallet onto a nearby shelf. The pallet knocked another pallet forward, causing it to fall onto the injured employee's shoulders. The employee suffered fractures in their right and left knees and ankles.

Employees were moving a single man lift into a building and reclining the lift to position it to fit through the door. The lift shifted and fell, causing the employee to sustain fractures to the left tibia and fibula. The employee was hospitalized and had surgery.

An employee was moving a light tower so it could be hitched to a truck. He grabbed the tongue of the trailer hitch on the light tower to slide it to the left. The tongue jack fell off, causing the light tower tongue to drop on the employee's right hand. The employee's middle fingertip was amputated.

An employee was working on disassembling and moving a trailer house from a gas well pad. The employee was on the roof of the structure installing flashing. The employee fell to the ground below, sustaining a skull fracture and brain bleed. The employee was hospitalized.

An employee was working on a truck when the truck's door fell on his hand, resulting in a partial amputation of the little finger.

The injured employee had been working on the computer at the front desk in the showroom. An argument occurred with another employee and additional people got involved. Gunshots were fired. The employee was shot in the hip and was hospitalized.

An employee was working on the lift gate of a truck when their left ring fingertip got caught in a pinch point, resulting in amputation.

An employee was preparing to remove leaf spring bushings on the front drive axle of a tandem axle tractor. After raising the axle with a hydraulic jack, he placed two jack stands under the rear frame rails of the tractor and placed additional jack stands under the front drive axle. He then repositioned himself at the rear of the tractor where he reached for the release valve of the jack to begin lowering the axle (and frame) onto the jack stands. He was in a kneeling position while using his right hand to operate the release valve. His left hand was caught between the lowering frame rail and a jack stand. His left ring and middle fingertips were crushed, resulting in amputations.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.